Van Beest Jaw & Eye
$16.39
Min. order of 4 required
SKU: JETBGV38X6-VB
Van Beest Green Pin®Jaw & Eye turnbuckles are designed with a jaw fitting on one end and an eye fitting on the other end. Jaw ends up to and including 5/8" are fitted with bolts and nuts, sizes 3/4" and up are equipped with pins and cotters. Eyes are forged and elongated for easy assembly and more uniform stress distribution.
Series G-6315 Green Pin® turnbuckles are suitable for lifting applications when used according to Van Beest"s official instructions for use. These hot dipped galvanized turnbuckles have a proof load equal to 2x WLL and MBL=5x WLL.
The Green Pin® brand has earned a reputation as an industry leader in design and quality standards and is compliant within a wide range of nationally- and internationally-recognized standards such as ASTM F1145-92 (formerly U.S. Federal Specification FF-T-791b). Turnbuckles are drop forged high tensile steel SAE 1035 or 1045.
Green Pin® turnbuckles are generally marked with WLL, manufacturer"s symbol, thread diameter, traceability code and thread.
Upon request, Green Pin® turnbuckles can be supplied with a works certificate and a proof load test certificate.
NOTE: Turnbuckles are intended for straight or in-line pulling only.
During tensioning, make sure no deformity of this product occurs. In case of deformity, the tension should be decreased immediately and deformed parts should be replaced. Extreme circumstances or shock loading, if applicable, must be considered when choosing the correct products for your application. Green Pin® turnbuckles are recommended for the rigging of wires, ropes, rods etc. The Working Load Limit (WLL) should be applied in a straight pull only and overloading is not permitted. Side loads should not be applied.
It is not permitted to adjust the length of the turnbuckle under full load. Tensioning below the WLL is permitted. It is recommended to first adjust the length of the turnbuckle and then load the turnbuckles to a certain tension. The tension should not exceed the WLL.
We also sell Van Beest turnbuckles with the following end fittings: Jaw & Jaw and Eye & Eye.
Series G-6315 Green Pin® turnbuckles are suitable for lifting applications when used according to Van Beest"s official instructions for use. These hot dipped galvanized turnbuckles have a proof load equal to 2x WLL and MBL=5x WLL.
The Green Pin® brand has earned a reputation as an industry leader in design and quality standards and is compliant within a wide range of nationally- and internationally-recognized standards such as ASTM F1145-92 (formerly U.S. Federal Specification FF-T-791b). Turnbuckles are drop forged high tensile steel SAE 1035 or 1045.
Green Pin® turnbuckles are generally marked with WLL, manufacturer"s symbol, thread diameter, traceability code and thread.
Upon request, Green Pin® turnbuckles can be supplied with a works certificate and a proof load test certificate.
NOTE: Turnbuckles are intended for straight or in-line pulling only.
During tensioning, make sure no deformity of this product occurs. In case of deformity, the tension should be decreased immediately and deformed parts should be replaced. Extreme circumstances or shock loading, if applicable, must be considered when choosing the correct products for your application. Green Pin® turnbuckles are recommended for the rigging of wires, ropes, rods etc. The Working Load Limit (WLL) should be applied in a straight pull only and overloading is not permitted. Side loads should not be applied.
It is not permitted to adjust the length of the turnbuckle under full load. Tensioning below the WLL is permitted. It is recommended to first adjust the length of the turnbuckle and then load the turnbuckles to a certain tension. The tension should not exceed the WLL.
We also sell Van Beest turnbuckles with the following end fittings: Jaw & Jaw and Eye & Eye.
